constraint question
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
BenRatt
- Senior Member
- Posts: 170
- Joined: Sat, Oct 22 2005, 10:59AM
- Location: Spartanburg, SC
- Contact:
constraint question
When I try to change the depth on this part, I get an error message and the part edits disappear. Does anyone have any ideas on how to do the constraints differently or is it a glitch? I want the holes to be 37mm from the front and back and be able to change the depth.
- Attachments
-
- LS12.hsf
- (120.02 KiB) Downloaded 380 times
-
- LS12.jpg (5 KiB) Viewed 3329 times
-
Nat Wheatley
- eCabinets Beta Tester
- Posts: 491
- Joined: Wed, Apr 15 2009, 8:22PM
- Company Name: Plymouth Custom Closets
- Country: UNITED STATES
- Location: Plympton, MA
Re: constraint question
Ben,
The attached file should work for you. I've substituted RTA fittings for your Part Editor cuts. You can control their placement through Construction Settings > Top Construction Parameters > KD/RTA Placement. I can post the Hole Editor file I used for the fittings, if needed.
Let me know if you have any questions.
Nat
The attached file should work for you. I've substituted RTA fittings for your Part Editor cuts. You can control their placement through Construction Settings > Top Construction Parameters > KD/RTA Placement. I can post the Hole Editor file I used for the fittings, if needed.
Let me know if you have any questions.
Nat
- Attachments
-
- LS12.hsf
- (96.02 KiB) Downloaded 369 times
http://www.plymouthcustomclosets.com
Dell Precision 490/ Intel Xeon 3.20 Ghz/3 GB RAM/ Nvidia Quadro FX 3450/ Windows XP, sp 3
Dell Precision 490/ Intel Xeon 3.20 Ghz/3 GB RAM/ Nvidia Quadro FX 3450/ Windows XP, sp 3
-
BenRatt
- Senior Member
- Posts: 170
- Joined: Sat, Oct 22 2005, 10:59AM
- Location: Spartanburg, SC
- Contact:
Re: constraint question
I didn't think about doing that Nat, I guess it just didn't occur to me since I had deleted all the other parts to the cabinet. Thanks a bunch!
But... on other cabinets I have this issue where I have dowels as the KD fitting and I want to use Rafix also. When I change the depth the part edits for the rafix disappear.
But... on other cabinets I have this issue where I have dowels as the KD fitting and I want to use Rafix also. When I change the depth the part edits for the rafix disappear.