Hardware Hole Issue

Nat Wheatley · Post by **Nat Wheatley** » Fri, Jan 21 2011, 7:27PM

In making changes to a hardware hole pattern, the changes aren't showing up when I reapply the pattern to a part (in this case used for an RTA fitting). When I go back into the Hardware Hole Editor and re-open the pattern, the changes have been saved.

I've tried applying an alternate pattern to the part, to clear out the old pattern, then applying the new pattern, but the old, unrevised version of the pattern keeps showing up. The only way I'm able to implement the changes, is to create a new name for the pattern, then apply it.

Anyone else come across this?

Kerry Fullington · Post by **Kerry Fullington** » Sat, Jan 22 2011, 8:04AM

Nat,

Scott and i talked about this a while back and he was able to reproduce it so I hope it is fixed in the next release. Until then you just have to use a new name.

Kerry

Nat Wheatley · Post by **Nat Wheatley** » Sat, Jan 22 2011, 8:58AM

Thanks Kerry.

Scott G Vaal · Post by **Scott G Vaal** » Sat, Jan 22 2011, 11:10AM

Yes, Kerry brought this to my attention and it is/will be resolved. Thanks Kerry and Nat.

Thermwood / eCabinet Systems

Hardware Hole Issue

Hardware Hole Issue

Re: Hardware Hole Issue

Re: Hardware Hole Issue

Re: Hardware Hole Issue