Score Sheet

Jason Stephenson · Post by **Jason Stephenson** » Thu, Jun 30 2011, 4:09PM

Just A quick question we were going to update our bottom score sheet and were just wondering whether the mdf has to be a certain density or is it just normal mdf

jason galbraith · Post by **jason galbraith** » Thu, Jun 30 2011, 4:31PM

I believe it has to be an LDF - Low Density Fibreboard and is not cheap. Can anyone confirm or deny?

Kerry Fullington · Post by **Kerry Fullington** » Thu, Jun 30 2011, 4:37PM

Jason, Jason,

In another thread about this still another Jason, Susnjara stated that the table boards that come with the machines are 32 lb density and the waste boards are 48 lb density.

Josh Rayburn · Post by **Josh Rayburn** » Fri, Jul 01 2011, 6:18AM

"Ultralight" or low density fiberboard for a spoilboard does not perform well with our vacuum and tends to hold more stress after it's machined (even on both sides) and so consequently is not a good choice. It also does not hold up well as a wasteboard. Premium (double refined) MDF as a spoilboard is the best choice, and regular or premium MDF for wasteboards has worked well.
jnr

Jeremy Schiffer · Post by **Jeremy Schiffer** » Wed, Jul 13 2011, 11:09PM

Josh, would that be what some companies call a "door core" MDF, such as Ranger board? (referring to the spoil board, not the waste board)

Josh Rayburn · Post by **Josh Rayburn** » Thu, Jul 14 2011, 3:59AM

Yes, Rangerboard is a great choice for a spoilboard. That is what I currently have and it also holds up better to wear which translates into less often machining of the spoilboard.
jnr

Thermwood / eCabinet Systems

Score Sheet

Score Sheet

Re: Score Sheet

Re: Score Sheet

Re: Score Sheet

Re: Score Sheet

Re: Score Sheet