G803

Will Williamson · Post by **Will Williamson** » Thu, Oct 25 2012, 4:53AM

Can you make the G803 the default acceleration factor?

Georgi Baltov · Post by **Georgi Baltov** » Thu, Oct 25 2012, 8:53AM

Hi Will, you can add the code in the program header in settings. I've done it on our machines.

Will Williamson · Post by **Will Williamson** » Fri, Oct 26 2012, 8:33AM

Thanks Georgi is that the factor you used ?

Georgi Baltov · Post by **Georgi Baltov** » Fri, Oct 26 2012, 8:59AM

Brad McIntosh · Post by **Brad McIntosh** » Fri, Oct 26 2012, 9:52AM

Will,

As Georgi stated you can add that G803 code to the "Header".

You can access the parameter field that via [SETTINGS] -> [SHEET MACROS].

Whatever you place in either the "Header" or "Footer" section will be added to the NC program verbatim, so make sure that the commands are syntactically correct in order to avoid program errors.

Thermwood / eCabinet Systems

G803

G803

Re: G803

Re: G803

Re: G803

Re: G803