Width of angled back on corner cab

[Tim Massa]

Would anyone be able to remind me if there is a way to change the width of the angled (center) back of the 90 degree corner cab? If it can be eliminated at all?

Thanks,
Tim

[Scott G Vaal]

Tim,

This is controlled by the Corner Gap setting on the Corner Settings tab of construction settings. If you make it a larger value, the center back will get wider. If you set this to zero (0), it will remove it all together. Hope this helps.

[Tim Massa]

Thanks Scott!

[Dennis Englert]

Also, the width of the center back is double the corner gap.

Dennis