Hardware

[Ariane Labrecque]

Hello everyone!

I have a question (don't know if it's a simple one or not)...

I am trying to understand how (if it's possible) I can integrate a hole pattern that isn't in relation with a door/drawer/drawer box.

I get that I have to create the hole pattern in the hole pattern editor. But if my geometry has to be mounted under the cabinet (under the deck) how can I apply it to the selected part and all?

I want to be able to set the hole pattern for a particular type of leveler. So for one cabient, I would have 4 levelers positionned on four different corners of my cabinet.

[Scott G Vaal]

Ariane,

Here is an example of using the KD/RTA construction and a special hole pattern to achieve holes on the deck for levelers. I will attach the cabinet and the hole pattern I made and used (I had to rename the extension for the pattern file to .txt to attach it here -- just rename it to .ptn after downloading it). Hope this helps.

[Ariane Labrecque]

And how can I do that?

Does a tutorial of this already exists?

[Ariane Labrecque]

Ariane,

Here is an example of using the KD/RTA construction and a special hole pattern to achieve holes on the deck for levelers. I will attach the cabinet and the hole pattern I made and used (I had to rename the extension for the pattern file to .txt to attach it here -- just rename it to .ptn after downloading it). Hope this helps.

KD Leveling Feet Example.jpg

How can I do that?

Does a tutorial of the specific steps to achieve this exist online?

[Scott G Vaal]

And how can I do that?

Does a tutorial of this already exists?

Not a specific tutorial, but using KD/RTAs should be covered and the Hardware Hole Editor. I suggest that you start with those sections of the videos and then ask any specific question you may have after that here on the forum.

[Dennis Englert]

There are video tutorials of using template files with the Part Editor in our subscription based training program.

Dennis