When it returns to make the final depth pass, it does not do the candy cane.
Also, when moving from the end of the initial pass to the beginning of the next pass, it doesn't seem to be a G00 move.
Tenons & bit max. depth
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Jeremy Schiffer
- eCabinets Beta Tester
- Posts: 1149
- Joined: Tue, May 10 2005, 9:36PM
- Company Name: Corlane Custom Cabinetry LLC
- Country: UNITED STATES
- Location: Carnesville, GA
- Contact:
Tenons & bit max. depth
When cutting tenons of a certain thickness where the cutting depth is greater than the maximum depth specified for the tool, the result are the candy canes as per the attached photo.
When it returns to make the final depth pass, it does not do the candy cane.
Also, when moving from the end of the initial pass to the beginning of the next pass, it doesn't seem to be a G00 move.
When it returns to make the final depth pass, it does not do the candy cane.
Also, when moving from the end of the initial pass to the beginning of the next pass, it doesn't seem to be a G00 move.
http://www.corlanecabinetry.com
AMD Ryzen 5 7600X 6-Core Processor 4.70 GHz, 64GB RAM, NVidia RTX A2000 12GB, Windows 10 64 bit
CS-41 4x8
CS-45 5x12
AMD Ryzen 5 7600X 6-Core Processor 4.70 GHz, 64GB RAM, NVidia RTX A2000 12GB, Windows 10 64 bit
CS-41 4x8
CS-45 5x12
-
Clint Buechlein
- Thermwood Team
- Posts: 753
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Tenons & bit max. depth
Jeremy,
Can you post an export of your settings please? Also if you have the code from these parts being created, as well as the non rapid issue so we can compare that would be great.
-Clint-
Can you post an export of your settings please? Also if you have the code from these parts being created, as well as the non rapid issue so we can compare that would be great.
-Clint-