Dust left from cutting

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand

Post by Thom Davies »

Cheers Paul I'll have a look!

Thanks

Thom Davies
Top
CameronEchols
Junior Member
Posts: 38
Joined: Mon, Aug 08 2005, 5:37PM
Location: mesa AZ

Post by CameronEchols »

I have a small trash can that is shorter than my router that I sweep the dust into then slip under the table. Than blow any thing left off.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”