Hi everyone, this is a first for me. I have attached a pic.
I have a batch of cabinets, when I click on nest diagrams I get this message pop up multiple times. I just keep clicking OK!
I tried searching the forum...nothing
Any ideas?
Problem with edge banding
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Ian Richardson
- Junior Member
- Posts: 81
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
Problem with edge banding
- Attachments
-
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Problem with edge banding
Ian,
Can you post the cabinet (or job of cabinets), and if they were made from seed cabinets, those cabinets? If it is too large to post, you can upload here https://info.thermwood.com/thermwood-file-upload-page, just make sure to reference this thread.
There is a mismatch between parts and edge banding data that some customers have discovered. Its becoming difficult to pinpoint, so this is a new error message added to 6.2.9 to help detect it.
-Clint-
Can you post the cabinet (or job of cabinets), and if they were made from seed cabinets, those cabinets? If it is too large to post, you can upload here https://info.thermwood.com/thermwood-file-upload-page, just make sure to reference this thread.
There is a mismatch between parts and edge banding data that some customers have discovered. Its becoming difficult to pinpoint, so this is a new error message added to 6.2.9 to help detect it.
-Clint-
-
Ian Richardson
- Junior Member
- Posts: 81
- Joined: Fri, Feb 15 2013, 5:21PM
- Company Name: Millworx
- Country: CANADA
Re: Problem with edge banding
Thanks Clint, next time it pops up I will upload
