Hardware hole editor

[Mark McCallum]

I am trying to create a square hole for some recessed handles in the hardware hole editor.
I can drag out the square pattern but when I try numerical entry of the co-ordinates the first dimension takes but the second dimension defers to 0,0

Does anyone else have the same results?

Thanks
Mark

[Kerry Fullington]

Mark,

HERE is a link to a video showing what I get with your entries.

[Mark McCallum]

Thanks Kerry.
Nice vid.
I am about tie a rope around this computer and turn it into a boat anchor.
It must be this graphics card, I ended up turning off the force software rendering I needed to get the rendering to work.
It was just slowing the whole of ecabs down and could hardly handle 3 or so cabinets in an assembly, and I can turn it on if I need to render.
Turning that setting on and off doesn't affect this.

Still not working for me.
https://youtu.be/G2JFwMpAG0o

I'll work it out somehow. Thanks for the help

[Kerry Fullington]

Mark,

Notice that when you enter your first set of coordinates and hit enter the entry method changes from Absolute to Incremental.
This happened to me as well the first time I tried this. When it happened, I selected the ABS radio button again and everything worked from there.

[Mark McCallum]

That"s very perceptive Kerry!

I hadn't noticed that.
And when I switch it back it works for me.

A little tricky test for the noobs like me.

I failed................

Thanks for your time and help again.
Mark.

Ps I might have to put making the boat anchor until next time.