I don’t know what causes this but its pretty standard on a lot of units.
The door or drawer fronts need replacing with the same door or drawer fronts because something happens to them when saved .
Anybody else have these things happen?
So on this drawer bank I delete the two top cutouts in the part editor.
Leave the stretcher rails and cutouts
Come back to the main screen.
resize to 400 wide, accept loose part editor cuts on the deck
Go to drawer door editor
Ctl A
Delete
Go to settings, set Top drawer / door settings to 20mm
Select opening
Add drawer. change to 4
accept Ok to implement and add drawers
These error messages pop up x 4
To Fix
Go to drawer door selection.
Load default (Door or drawer front)
Error MSG. error in creating cutpath segments. hit OK
Hit load again, because that thing where the details don’t load properly and you just need to refresh to get it to show the details.
Same Error MSG. error in creating cutpath segments. hit OK again,
Directories appear.
Go to directory. Reselect the same door or drawer again.
Drawers can now be added / changed as per normal
Some time between saving this now good drawer bank and reloading and changing the door / drawers, it probably will need reseting the drawer door fronts,
- DDR 600.jpg (11.49 KiB) Viewed 98 times