Cut through errors

David Giesbrecht · Post by **David Giesbrecht** » Mon, Sep 26 2016, 3:15PM

code.doc: (31.5 KiB) Downloaded 818 times

Don't know when it started but every once in a while the last side on the pcs the cut through will be way off. See attached, highlighted at the bottom of the code. Notice the height on three sides is -5.63 then the last side is -9.13. (all metric) An ideas???

Will Williamson · Post by **Will Williamson** » Fri, Sep 30 2016, 5:16PM

Have you contacted tech support?

Thermwood / eCabinet Systems

Cut through errors

Cut through errors

Re: Cut through errors