off fall nesting over parts

Matt Beaty · Post by **Matt Beaty** » Fri, Oct 13 2006, 10:24AM

I have been running into a nesting issue where the off fall from my machine is cutting into my parts when it outlines. Sometimes it shows on the sheet printouts and sometimes it doesn't. This is becoming costly as it mainly happens on finished end material. Does anyone have any suggestions? Attatched is the twd. file for a looksee.

Larry Epplin · Post by **Larry Epplin** » Fri, Oct 13 2006, 1:03PM

Matt,

Please post your machine.ini & tools.thm They are located in the c:\\Rolling Nest directory.

Larry