can't get door to have 1/2\" gap at bottom
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Mark P Sullivan
- Junior Member
- Posts: 56
- Joined: Wed, May 18 2005, 6:42PM
- Location: Big Sur, CA
can't get door to have 1/2\" gap at bottom
maybe this is a inset frame issue. No cabinet floor in this closet. When I set the bottom gap to 1/2\" it ( there is no bottom frame) it comes out flush, even though the door ht. in the door settings dialouge it shows the right ht.
- Attachments
-
- Sena bath 202 wc closet 203.zip
- (576 Bytes) Downloaded 493 times
psalm3737
Mark Sullivan/Big Sur Woodworks
Post Ranch Inn
HC 67 Box 1363
Big Sur, CA 93920
Mark Sullivan/Big Sur Woodworks
Post Ranch Inn
HC 67 Box 1363
Big Sur, CA 93920
-
Justin D Melhiser
Mark
Can you send me the .hsf file directly to me email or send the job file to me.
My email is cabinets@thermwood.com
Can you send me the .hsf file directly to me email or send the job file to me.
My email is cabinets@thermwood.com
