Toe Kick

Joe Ford · Post by **Joe Ford** » Sat, Jun 09 2007, 7:54PM

I build my cabinets with the toe kick attached to the front side of the end panel instead of between them. However, I can't seem to find out how to make this happen in ecabinet systems. I would appreciate any suggestions anyone might have.

George Davidson · Post by **George Davidson** » Sat, Jun 09 2007, 10:34PM

This is the way I do it

Michael Yeargain · Post by **Michael Yeargain** » Sun, Jun 10 2007, 8:10AM

Your full dado depth should the same thickness as the end panel. George is using a 3/4\" generic material therefore the depth of the full dado will be 3/4\"

Joe Ford · Post by **Joe Ford** » Sun, Jun 10 2007, 4:09PM

Thanks guys... I have been searching for a way to do that for a really long time.

Joe

Kerry Fullington · Post by **Kerry Fullington** » Mon, Jun 11 2007, 6:26AM

Joe,
You don't have to use the full dado trick any more. Go to the Toe Kick tab in Construction Settings and add a negative left and right inset to the kick that is equal to the thickness of your end panel materials. This will lengthen the kick.
Kerry