Thermwood / eCabinet Systems

Thanks Todd... I have been beating my head against the wall for a week trying to figure this out... i feel really stupid now because it was something so simple... Thanks again

I have a problem with the program taking 1/4" off of all door and drawer fronts when it generates the cut list. I has only started this with this last job and it makes me wonder if I am doing something wrong. It shows them correctly in the cabinet editor (correct size) but a door that is 22H x15W ...

Hey everyone. I am still new to this software and learning really fast (at times). However, I have a question about angle cabinets. I need to build a cabinet or two where the front (face frame) is 30\" wide and the back is 50\" (roughly a 22.5 degree angle from front to back on both ends). I have ...

Thanks guys... I have been searching for a way to do that for a really long time.

Joe

I build my cabinets with the toe kick attached to the front side of the end panel instead of between them. However, I can't seem to find out how to make this happen in ecabinet systems. I would appreciate any suggestions anyone might have.