Inset handle route

[Dave McPherson]

Hi Everyone,
I am trying to route a slot for an applied inset handle. The CNC is leaving alittle bit left over in the center. The cabinet was drawn in e-cabinets, i am not sure if this is a ecabinets issue or a Thermwood CNC setting. Any help would be greatly appreciated.

Thanks,
Dave

[Dave McPherson]

ecabinets pick

[Dave McPherson]

ecabinet image

[Jason Susnjara]

Hi Dave,

Can you post a screen shot of your settings window in Control Nesting?

thanks,

[Dave McPherson]

Hi Jason,
Attached is a pick of the control nesting


Not a big deal, but i can not get the ALT-PRINT SCREEN feature to work from the machine keyboard. So, i took a digital pick

Thanks
Dave

[Jason Susnjara]

Hi Dave,

Can you also post the .hsf file for this part in eCabinets or you can email it to cabinets@thermwood.com?

thanks,

[Dave McPherson]

Thanks!

[Jason Susnjara]

Dave,

What tool cut the rout cut?

thanks,

[Dave McPherson]

Pocket tool setup

0.476\" Diameter.

Thanks,
Dave

[Jason Susnjara]

Hi Dave,

When I nest this I get a pocket routine. On yours, it looks like it tried to circle interpolate. Look at the pic below and does yours look like this on the screen? What version of Control Nesting are you using?

thanks,

[David Hall]

This is a bug in the spiral pocket routine. Change your \"step\" to 50% and all will be well.

Regards,
Dave

[Jason Susnjara]

Hi David,

I had mine set to Spiral with a 90% stepover and it worked. What version do you have installed?

thanks,

[David Hall]

Jason,

I'm still on 4.94. According to the release notes, it looks like this may have been addressed with 5.02.

Dave M.
What version of CN are you running?

Regards,
Dave