Missing mounting plate holes

Sebastien Boileau · Post by **Sebastien Boileau** » Wed, Jun 20 2007, 3:22PM

Since the last build i've been getting some upper double door cabinets cut on the machine with only one of the four sets of mounting plate holes drilled, and when I check the file in ecab, it shows the mounting plate holes (blue filled holes) but when I explode the cabinet the holes are actually not there...then if I hit enter to change a dimension, the holes are back. This does'nt happen often, I've only had about 4-5 cabinets since the last build update come back without the holes but it is a pain, any solution guys?
I attached the file of one of the cabs.

Walker T Scott · Post by **Walker T Scott** » Thu, Jun 21 2007, 8:32AM

Sebastien

This issue has been fixed in 5.1.3; do a construction settings ok and this will bring back your plate holes. Then save the cabinet and it will be fixed.
Walker

Sebastien Boileau · Post by **Sebastien Boileau** » Thu, Jun 21 2007, 10:28AM

Walker, I already have v 5.1.3, should it not do this already?

Walker T Scott · Post by **Walker T Scott** » Thu, Jun 21 2007, 10:36AM

Did you do a construction settings ok and save the cabinet?

Sebastien Boileau · Post by **Sebastien Boileau** » Thu, Jun 21 2007, 11:59AM

No not since the update....I guess that'll work, but why does it just happen once in a while that's what i dont get, it's like one for every 20-30 or so....