Lumicor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:
Contact Rick Palechuk

Lumicor

Post by Rick Palechuk »

Anyone have any tips on working with Lumicor? Cutting it is not a problem, it's the fabrication that is. We need to apply it to HPL. The architect has spec'ed 1/4\" Lumicor to be applied over plastic laminate as a decorative feature. The edges need to be bonded together to form corners and the material needs to fastened to the PL in a way not to distort the clarity of the product.
Top
User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Post by DanEpps »

Rick

According to the Lumicor website, you can use normal router bits, etc for working with it.
Top
Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:
Contact Rick Palechuk

Post by Rick Palechuk »

Thank you Dan. Cuttings not the issue, it's sticking it to the PL that is.
Top
User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Post by DanEpps »

The same site has binding info as well.
Top
Rick Palechuk
Wizard Member
Posts: 1896
Joined: Wed, May 18 2005, 7:54PM
Company Name: Milltech Millworks Ltd.
Country: CANADA
Location: Edmonton, Alberta
Contact:
Contact Rick Palechuk

Post by Rick Palechuk »

Thanks Dan
Top
Post Reply

Return to “eCabinet Systems Software”