Wall editing

Lee Gernandt · Post by **Lee Gernandt** » Tue, Jan 29 2008, 11:38AM

I had to change a wall dimension U-shaped room, by adding 1/2". It was the wall between the other two walls, and now it shows that one side is overlapping the other wall by 1/4".When I go to detail room, itshows that the wall is 148 1/2". But when I go to the LDE the most I can get is 148 1/4".When I zoom in on the finished view, you can see it also.Any help would be appreciated.

Justin Melhiser · Post by **Justin Melhiser** » Tue, Jan 29 2008, 12:18PM

Lee
Please post your job file here or email it to me. My email is cabinets@ecabinetsystems.com

DanEpps · Post by **DanEpps** » Wed, Jan 30 2008, 6:45AM

Make sure you have all of the connecting walls selected before resizing the center wall. See Working with a Custom Layout -> Adjusting walls in the Wall Editor in "eCabinet Systems Made Easy" on the help menu for details.

Justin Melhiser · Post by **Justin Melhiser** » Wed, Jan 30 2008, 9:54AM

Lee
I just wanted to check and make sure everything was correct and working properly. If you have any other questions or need to email me any other files, please do so.

Lee Gernandt · Post by **Lee Gernandt** » Wed, Jan 30 2008, 10:04AM

Thanks for the help. That's what I did wrong, I didn't make sure the connecting walls were highlighted. Seems like every problem I encounter usually falls into operator error.

Michael Yeargain · Post by **Michael Yeargain** » Wed, Jan 30 2008, 7:51PM

Lee Gernandt wrote:Thanks for the help. That's what I did wrong, I didn't make sure the connecting walls were highlighted. Seems like every problem I encounter usually falls into operator error.

To error is to be Human?

Thermwood / eCabinet Systems

Wall editing

Wall editing

Re: Wall editing

Re: Wall editing

Re: Wall editing

Re: Wall editing

Re: Wall editing