Test: place the door with the fewest keystrokes

[Gene Davis]

A frameless blind basecab is the today's challenge cup, and the file is attached.

The door has a 1/8" margin between itself and it's "stile" on the left, which is the spec for the Blum blind corner hinges used there.

Bottom reveal is zero, top reveal is 3/8", R side reveal is 1/8".

Take the cabinet, remove the door, and replace it so that you get the same reveals. It is a "faceframed" cab, with the only part of the faceframe being the 4" "stile" the door is hinged to, thus the door is inset 3/4".

I'll start the timer when you've loaded the file.

[Kerry Fullington]

Gene,

What seems to be the problem? Once you save your file with the door parameters there is no problem changing doors.

Kerry

[Gene Davis]

Load it up and go to work, Kerry.

Let's see what you need to do to get the job done.

[Kerry Fullington]

I did it before the last post.
3/4 inset
+1/8" Hinge side gap
-5/8" Open side gap
-3/8" Top gap
-3/4" bottom gap

I still don't know what you are trying to get at.

Kerry

[Damon Nabors]

Not sure what the problem is, changed doors for ya

[Glenn Warner]

Took about 5 minutes because I didn't get the constructions settings on the first try.
Hinge side gap: -.75"
Open side gap: .125"
Top gap: -.375"
Bottom gap: -.75"
Door inset: .75

Good practice. Thanks

Glenn

[Damon Nabors]

What happened to Gene, did his timer break?