DRAWER BOX ERROR

jerry johnson · Post by **jerry johnson** » Wed, May 07 2008, 12:13PM

After installing the 5.2 update I now have an error in the drawer box editor. When I add a drawer box the first message reads; "Failed in generating CNC data." I hit OK and this message pops up; "There was an unexpected error while handeling CNC data operation in Drawer Box edditor. Reverting to previous body." The drawer box is then added but it looks like the attachment. Is anyone else having this problem??

: DRAWER BOX ERROR.jpg (18.65 KiB) Viewed 9655 times

Walker T Scott · Post by **Walker T Scott** » Wed, May 07 2008, 12:19PM

Could you attach the cabinet file then the drawer box file too?
Thanks

jerry johnson · Post by **jerry johnson** » Wed, May 07 2008, 3:47PM

apple .485 PREFINISHED TANDEM BOX .5 BOTTOM.hsf: (52.02 KiB) Downloaded 814 times

DRAWER ERROR.hsf: (1.49 MiB) Downloaded 807 times

I hope I did this right. Thanks!

Walker T Scott · Post by **Walker T Scott** » Thu, May 08 2008, 8:45AM

The dado settings you are using on that drawer box are causing the problem. You will have to recreate your drawer box using the STD drawer box not any of the STD dovetail drawer boxes. I’ve got this listed for the programmers, sorry for the inconvenience.

Sergio Fetter · Post by **Sergio Fetter** » Fri, May 09 2008, 10:27AM

Hey Walter,
Speaking of drawer box. When I place a drawer base cabinet and I have to resize, the drawer box does not resize with it. Is there something that I can do, or is there something that I am not doing?
Thanks!

Walker T Scott · Post by **Walker T Scott** » Fri, May 09 2008, 10:39AM

Are you using the drawer box that you get the error from? Do you have minimum increment set for the drawer box that is not resizing correctly? Could you attach the cabinet with the drawer box before you resized it?

Sergio Fetter · Post by **Sergio Fetter** » Fri, May 09 2008, 10:45AM

Thanks,
Here it is.
Let me know the outcome on that.

Thanks again!

Rick Palechuk · Post by **Rick Palechuk** » Sat, May 10 2008, 9:17AM

Sergio, it resized for me OK.

Sergio Fetter · Post by **Sergio Fetter** » Sat, May 10 2008, 8:24PM

Rick,
I appreciated. I am not sure what I did there for a few minutes.
Thank you!

Lamar Horton · Post by **Lamar Horton** » Sun, May 11 2008, 8:41AM

That was happening to me as well. I would delete the drawer in the Door Drawer Editor the re choose the default drawer box and it works fine.

Rick Palechuk · Post by **Rick Palechuk** » Sun, May 11 2008, 9:00AM

That's weird, cause I just adjusted the width of the cab and it followed along like it should.

Thermwood / eCabinet Systems

DRAWER BOX ERROR

DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR

Re: DRAWER BOX ERROR