Bead Board

[Gary Puckett]

Does anybody have an image of Bead Board ?

Gary

[Vince Lisanti]

Gary,

Here are a few I use .

I just create a sheet material using these images.

Vince

CCS woodworks inc.

[Gary Puckett]

Vince,

Thanks, I copied the picture and when I went to add a new image in the material section no image came up. Any ideas why no image came up?

Gary

[Wally Schneeberger]

You have to put it in your image file under a heading like IMPORTS.

Image.jpg (200.26 KiB) Viewed 6308 times

[Gary Puckett]

I did I called it Bead Board

[Vince Lisanti]

Gary,

I am not sure why the images will not show up for you ?

The only thing I can suggest is to add the images to your material folder with e-cabs shut down and see if that works.

Find your ecabs folder than your materials folder add a new folder in there called beadboards, open this folder and copy and paste the beadboard images to this folder.

Close down your folders and fire up ecabs. Settings/Preferences, Define Stock Materials, Sheet Stock , Select Image, Beadbords, (You created this folder earlier) The beadboard images should now be in here.


Good Luck

Vince

CCS