How do you miter Enkeboll molding

[Gary Puckett]

Can you miter molding from Enkeboll and if you can how do you do it?
I thought I could just take it to the part editor but it does not support it.
Is this something that the system can't do, or am I missing something.

Thanks
Gary

[Todd Miller]

Gary,
Usually if the molding is in the software already, you can select the molding in the "load items" screen. Then set the length and the mitre angles for each end.

[Gary Puckett]

Todd,

This molding is one you have to convert to a stl file

Gary

[George Davidson]

Hi Gary Could you show me the Molding from Enkeboll

[Todd Miller]

Gary,
Post the stl file and we can take a look at it. But I am pretty sure you are going to need to mitre the edges and set the length before you bring it into eCabs.

[Gary Puckett]

Here is the molding

[Gary Puckett]

Hi Gary Could you show me the Molding from Enkeboll

George here is the molding right above this post. I think what you have to do is miter it in another cad program then bring it to eCab. I am not that experienced with cad progams to do that. I can just convert dwg and dxf files to stl sometimes

Gary

[George Davidson]

Try this or giveme the sizes you need
I did not try to resize

[Gary Puckett]

Thanks George,

It will scale to any size but the shorter you go the 45 degree miter changes. I think if you check the box in the scaling box it looks like it doesn't affect it.

I have intellicad could you tell me the steps to create this miter so I can do it in the future.

Thanks
Gary

[George Davidson]

Try this DWG File

[Gary Puckett]

No that didn't work. I must have been half asleep last night because when I check the box it did nothing.