Cut List

[George Davidson]

I made a molding rack for our shop.
Cut list tells me 3-Sheet of 1/2" plywood
Batch material tells me 2- sheets
The batch is right
Here is another batch

[George Davidson]

Here is the Rack in ZIP File
It is the rack back of the panel saw.
Made of 1/2" plywood and exter Plasic Balusters

[DanEpps]

The cut list BEFORE nesting is based only on total square inches and cannot be relied on for accuracy. ALWAYS nest before producing a cut list.

[George Davidson]

Thank You Dan
I for got you did say that before

[DanEpps]

Maybe the cut list should have a disclaimer to that effect if it is produced pre-nest?

[George Davidson]

I am not sure what I did it still comes up with 3-Sheets cut list

[DanEpps]

Did you run the cut list from the nest?

[DanEpps]

I gives 2 sheets for me, both before and after nesting.

[George Davidson]

Thank You Dan
So I get the right cut list just when I am in the batch.
I was thinking if I batch it and came out into Cabinet Editer I would get the right cut list then

[DanEpps]

Batch it, nest it then create the cut list while still on the nest screen.

[George Davidson]

I said batch I sure of said (nest screen)
I need more coffee

[George Davidson]

Molding Rack Done
I can't get my self to put trim on the rack if it could just stay like that