Resize Cabinet problem

[Paul Amos]

I look forward to joining the eCabinets forum now the software has been made available to Shopbot owners.


I need a bit of help, please.

I am try to resize a cabinet from the frameless 32 system, everything resizes ok except the base, what am I doing wrong ?

Paul

[DanEpps]

How are you going about resizing the cabinet? Put the new size in the size box and press "enter" and it should resize correctly (although I haven't downloaded that library and tried on them).

[Gary Puckett]

Paul,

Have you tried deleting the deck and then adding the deck back?

Gary

[Paul Amos]

Thanks Guys

Dan,

That's how I resized the cabinet.

Gary,

I tried your method and it worked fine, but I lost all the fitting holes, so I think it is a constraint issue.



Paul

[DanEpps]

...but I lost all the fitting holes, so I think it is a constraint issue...

Definitely. Take a look at the constraints and see how they are setup. You can probably change them so the cabinet can be resized.

[Kenneth Rychlik]

Paul,
Did you resize just before placing it in the room, or after it was already in the layout? It seems to work better for me to resize when I choose the cabinet, but before placing it in the room.
Kenneth

[Paul Amos]

Ken,

I resized it before placing it.

Paul

[Paul Amos]

I found the problem.........


In the constraints settings the first line of leg mounting holes had a setting of 11mm from the end of the panel, this was on the front and the back, I removed the contraint on the back and everything resized fine.