Problem Trimming Flip-Ops First

[Kerry Fullington]

A problem has occurred after updating to Control Nesting V5.66

Under Flip Ops First I select Cut Flip Operations First then Trim Sheet and then select Pin Area Only

When I look at the code it is trimming 3 Sides Not just the pin area

I then notice I can select more than one radio button in the flip ops first dialog

[Joe Harger]

Kerry, this problem has been reported to the programmers and a fix for it should be available next release...I have talked with Keith as well and let him know.

Joe Harger
Software Support
Thermwood Corporation

[Kerry Fullington]

Thanks Joe,

Keith would like to revert back to the previous version of control nesting. Is that possible?

Kerry

[Joe Harger]

I have talked with Keith and we have already discussed that and he is going to wait until the release. I will keep in contact with him and if the release takes longer than he likes then I can
help with his previous version.

Joe Harger
Software Support

[Wayne Adelkopf]

Kerry,
Curious, why do you trom 3 edges?

[Kerry Fullington]

Wayne,

I only want to trim the pin area of two edges but after updating control nesting to version 5.66 that is broken.
If I selected Trim Pin Area only the machine did not trim anything.