Part Editor

[Dan Calvert]

When trying to load a dxf file into PE to create a part ecabinets locks up. This same procedure is still working on my desktop which still has version 5 running. Anyone else tried this yet with version 6?

Everything else is running fine so far with version 6.

[Rick Deskins]

Can you post the dxf file?

Thanks

[Dan Calvert]

I don't seem to be able to load a dxf file. I get a note stating the dxf extension is not allowed. I can email it to you. The file I created was a simple 2
D design made in Quickcad from Autodesk which is an autocad based program.

Dan

[Rick Deskins]

You can zip the file, then post it.

[Dan Calvert]

Rick,

I am not ignoring you I am having troubles with getting a activation code for Winzip. As soon as I get the code I will zip the file.

Thanks,
Dan

[Kerry Fullington]

Dan,

Right click on your file then choose Send to then Compressed folder and that will zip it without winzip.

Kerry

[Dan Calvert]

Kelly,

Here is the file. It is not anything in particular just something I created to practice making dxf files.

[Josh Rayburn]

I have no problems with the DXF file being overlayed on a part here.
jnr

part1.jpg (47.73 KiB) Viewed 8594 times

[Dan Calvert]

I too was able to use the dxf file on my computer with version 5 still installed it is only when I use it on my computer using version 6. I quess this eliminates the file as the problem. I must have a problem with the installation of version 6 however, everything else seems to be running fine. At least so far. Does anyone suggest that I try reinstalling version 6?

Dan