Thermwood / eCabinet Systems

i agree with clint our ramp in depth is 5/16" or 8mm

hi I'm new to vcarve and dealing with post processors and found these posts that clint posted.
the G52L1 on line 105 i have a question about
why is it here? i don't have a fixture offset set up but it moving my pieces on the Y axis down not tight to the end

if anyone else has tips or tricks please ...

In control nesting in settings under flip ops first make sure "do not allow flip parts on added sheets or off-fall" is not checked off.
Its the second button from the top

cam we get patch notes?

Thanks clint,
i didn't realize it had its own menu. Still lots to discover in this program

i have a user defined operation attached to a KD/RTA hole pattern

When i change the max distance in the construction parameters the hole pattern moves but the user defined operation stays fixed, which causes a mismatch.

please see attached sample cabinet and screenshot.
user defined operation ...

i have cut full perimeter selected. with ignore settings grouping checked off

this is a weird one.
load a job with one piece in control nesting, nest x or y, add a new empty sheet and nest, confirm that the empty sheet is is removed. the drawings with show the sheet and its off fall as being cut. but when you cut it does not do outline cuts for the off fall. and if you print ...

this is really strange i measure all my tools but on the last one when it was doing the medium loop it raised the machine up till it was out of envelope.
any suggestions? can i just add a negative to the z value in line 87?
please see attached program file

Hi clint
sorry for the long delay but here is a cabinet with that drawer in it. in my instructions you will want to switch to back view in the part editor to see the original cuts

Why does the cutting tool go way past the edge of the sheet when doing the trim operation for flip ops?
We were cutting a 10 ft piece on our machine CS43 5x12 and it crashed into the tool holders and went into e stop.
should the program check that its not exceeding its table boundries?

We use blum legra boxes and we get the cnc for cut the groove on the sides for us.
Pick a cabinet with this type drawer box load it into the assembly editor and then take the drawer box bottom or back into the part editor and make a rectangular cut and then cut through using geometric shapes then ...

we use this from FS tools with a small break thru amount

Can you add the border lines back to the parts when nested?
the new look is very hard to look at posting old and new as examples
new style old style

It would be nice if control nesting could display the sheet sizes when nested as I have had to work with product that is 49"x97" and also product that is 48.5" x96.5" and its easy to miss. Also it would be helpful when nesting with alternative widths and lengths from eCabinets.
see my sample below ...